18300Y, Truck Lite Model 18 Yellow Clearance/Marker Light Kit (Light, Plug, and Mounting Gasket)

• 18300Y
• Model 18 Yellow Clearance/Marker Light Kit (Light, Plug, and Mounting Gasket)
• Sonically Welded Lens and Housing
• Replaceable bulb
• Not Suitable for PC Requirements
• Replaced Signal-Stat 1572/1572A
• Voltage: 12
• Wire Gauge: 18
• Incandescent Lights
• Number of Diodes/Bulbs: 1 
• Number of Wires: 2
• Lamp Connection: Socket Assembly
• Plug Side One: Socket Assembly
• Plug Side Two: Ring Terminal / Stripped End
• Lens Shape: Rectangular
• Lens Color: Yellow
• Mount/Trim Color: Yellow
• Housing Material: ABS
• Lens Material: Acrylic
• Compliance Family: FMVSS 108 / CMVSS 108 / DOT / SAE
• Mount Type: 2 Screw
• Mounting Connector Diameter: 0.2 inches
• Lens Width & Height: 4.5 x 1.63 inches
• Made in the USA
• 1 Year Warranty

Model 18 Clearance/Marker Light (Red):  18300R

Replacement Parts:

• Lens: 99012Y
• Mounting Gasket: 97927
• Plug: 94940
• Wagner Miniature Bulb (10/Pack):  194

Truck Lite Marker & Clearance Lights

Cross#'s: 01-CT-18300YL, 01-CT-18300Y, 1941368, TRU-18300Y, 18300Y, LK3560, 2061528, 18300Y4, 25172900, 45713, 99012Y, 10027740, 97927, 99012Y, 94940, 0735111039587

VMRS:  034-004-024

Related Items - Blue Bird Part #'s: 

Bulb: 10027740 (Part#: 194)

Gasket: 97927

Lamp Assembly: 99012Y

Plug: 94940

What lights do I need?

Check the specific vehicle requirements or contact Truck-Lite Technical Support. Note that states cannot require anything different than what is in FMVSS-108; however, states can add regulations. Contact Truck-Lite for special situations.

How hard should I tighten down (torque) plastic lights or devices?

Over-torqueing will generally cause cracking or distortion. Use the torque specifications provided by the manufacturer. A marker light will generally be in the neighborhood of 8 to 20 inch lbs., but a good rule of thumb is to use the minimum torque necessary to secure the device.

I'm painting my vehicle, what if I get some paint on the lens?

You should be careful to avoid getting paint on the lights; most paints (excluding water based) are incompatible with polycarbonate lights. They may also cause wires or cable insulation to crack.